Injection Pressure Control Sensor ICP For IC Corporation DT466 Engine

Dt466 Injection Control Pressure Sensor Location. Alliant Power Injection Control Pressure (ICP) Sensor, 19982003 To see if the ICP sensor is bad unplug it and run the engine • If injection control pressure increases above 28 MPa (4061 psi) (4.45 V), the mechanical system is operating correctly for the engine to start.

I replaced my ICP sensor on my dt466e engine to solve error codes 164-4 and 164-10 Diagnostic Trouble Code 332 will be set by the ECM if the signal from the ICP sensor is higher than expected with the engine not running.

1812818C93 ATP DT466 Injection Control Pressure Sensor ICP Advance

If you have an air compressor that may compliate things See "DT 466 Performance Specifications" - Appendix A (page 595), "DT 570 and HT 570 Performance Specifications" - Appendix B (page 619) or Section 7 "Operational Voltages Checks. See How Easy It Is To Change A ICP Sensor On A DT 466 International Engine @dairleautoclassicrestorati6892 #truckmaintenance#truckrepair#injectorproblem

Diesel Injection Control Pressure Sensor Fits International 3200/4300. See How And Why To Replace A ICP Sensor On A 2006 International DT466 Engine @dairleautoclassicrestorati6892 #truckrepair#truckmaintenance #internationaltrucks Injection Control Pressure above Specification with Engine Off When code 332 is active the amber ENGINE lamp is illuminated and the odometer displays the message WARN ENG

Generic Injection Control Pressure Sensor For DT466E I530E HT530 DT466. It will turn on the engine light but don't worry about that Engine Mounted Components NOTE: For Water in Fuel (WIF) sensor and optional Engine Fuel Pressure (EFP) sensor location, see "Fuel Flow" in Section 1 (page 35)